The anti-flood artifact can be understood as a water retaining device, which is generally used in warehouses, factories, etc. The main function is to block rainwater. This flood control system has good sealing performance, prevents leakage, and has strong pressure resistance. There are many factors to be considered in the installation of flood control artifacts, which is extremely important, and a slight error will affect the use effect.
When installing the flood control artifact, the installation site must be cleaned first, and the installation tools must be prepared. The length of the anti-flood artifact is determined according to the width of the door specially used by the customer. When customizing, the width of the walls on both sides of the door needs to be measured, and the data needs to be accurate, with an error of 2mm. When installing, first prepare drilling tools and sealing tools: electric drill and glass glue. The electric drill is used to drill the jamb of the flood control artifact. Glass glue can seal the jamb and make it more secure with the wall.
Installation method of side column of flood control artifact
1. Clean the dust and garbage in the corners, make sure the walls and corners are clean, and there are no debris on the contact surface of the pillars.
2. Determine the position of the two side columns, a pair of side columns (middle column) must be kept in a straight line and marked.
3. The angle between the side column and the wall should be 90 degrees, and the position of the expansion screw should be marked on the ground and the column.
4. Choose the M14 drill bit to drill holes; before fixing the column, apply waterproof structural glue on the back of the column; after fixing the column with expansion screws, the gap between the column and the wall and the ground should be sealed with glue.
Installation method of the middle column of the flood control artifact
1. The size of the embedded part is 160 * 160 * 60 mm, and a groove of 165 * 165 * 60 mm is dug underground.
2. Fill the tank with cement, put in the embedded parts, calibrate with a level, and use it after the cement has solidified.
The use of flood control artifacts
Aluminum alloy flood control artifact is one of the commonly used water retention products. Aluminum alloy is a metal material with low density, high strength and good corrosion resistance. So far, it has been used to make some products with good sealing, high strength and large load-bearing capacity.
The flood control artifact is composed of several high-strength aluminum alloy plates. The anti-flood artifact made of aluminum alloy not only has good water retention effect, is convenient for water retention, and does not leak water, but also has a long service life and can be used repeatedly, integrating flood prevention and beauty.
The aluminum alloy flood control artifact is a combined structure of multiple aluminum alloy plates. For the convenience of use, each aluminum alloy plate is designed with a certain length and weight, and the installation is also very convenient. Generally, two people can install it. And each aluminum alloy baffle has waterproof tape, the tape is not ordinary tape, the EPDM soft tape at the bottom is specially made for our products, and the matching degree is very high. The purpose is to have better sealing performance and ensure that the connection interface does not leak. EPDM hard tape is commonly used in the market, which will cause water seepage and leakage.
Flood Control System Artifact Supplier - Yongjing
Jiangsu Yongjing Water Conservancy Technolog is known as Pearl of Taihu lake in Wuxi,Jiangsu. It is a supplier of prefabricated guardrail flood control systems, landscape flood control systems, municipal water conservancy flood systems, and emergency flood control equipment to!
https://www.yjslfloodwall.com/How-to-install-and-use-the-flood-control-system-artifact.html
Comments (0)