central dust collecting system has dust bag self-cleaning and artificial beating. Dust bag self-cleaning only depends on the dust layer attached to the surface of the dust bag falls off, so the dust fall is not large, and the pressure loss is only reduced. The pressure loss of the filter bag is generally reduced to 300pa. However, the dust removal rate decreased in a short time after re-operation. With the increase of filtration time, the dust collection amount on the surface of the dust bag increases, and the pressure loss limit also increases. In actual operation, the air volume in the system is reduced due to the increase of the pressure loss of the dust bag, and the pressure loss is reduced to. Therefore, the limit of this pressure loss is the fan pressure head when the air volume tends to 0. Under different dust-bearing gas concentrations and loads, with the increase of filtration time, the pressure loss of large concentration increases quickly, and the pressure loss of large load also increases quickly.
Below, explain the installation process of central dust collecting system in detail:
First, when installing the central dust collecting system, it is necessary to pay attention to the damage of the box and accessories, and the aperture of the tank top is less than the dust collector.
2. The central dust collecting system and other parts need to be inspected before installation. All the parts are in good condition.
Three, the installation of the filter cylinder in the dust collector needs to be fixed vertically in it, and it should be installed compact.
Four, the tank top should be welded on the ash storage tank top. Then switch on the induced draft fan.
Five, the dust collector needs the seal inside the box, can not appear any air leakage phenomenon.
Six, and then connect the air compressor, and also need soft connection. This is the way to connect to the dust collector reservoir.
Before operation and maintenance of the central dust collecting system selection, protective gloves should be worn first, the power should be cut off before the operation of the equipment, and the stability of all removable parts should be checked before use, and all the filter elements should be securely fixed on the flower hole plate, and the detection window should be closed. After use, the equipment should be tested every six months, and maintenance should be carried out. Our bag dust collector needs to determine the sealing inside the box body, and can not appear any air leakage phenomenon.
The installation of the filter cartridge in the central dust collecting system needs to be vertically fixed in it and compact. It is important to check the bag dust collector regularly, because we can find the problems existing in the central dust collecting system in time and solve them in time. The top of the tank should be welded to the top of the ash storage tank. Then the induced draft fan is connected and then the air compressor is connected, and soft connection is needed. This is the way to connect to the dust collector reservoir. All the parts are in good condition. If they are found damaged or deformed, they should be repaired in time and installed after no error.
central dust collecting system https://www.kaisenfilter.com/Central-Dust-Collector
Comments (0)