1. The voltage of fast wire and medium wire cutting should be controlled between 70-90V.
2, the processing current depends on the thickness of the workpiece to be processed to determine, generally cut the thickness of the workpiece below 70, the current control in 2-3A can be.
3. As for the current jumping to 4 all at once - it may be that your walking speed is too fast to cause a short circuit.
high accuracy mini universal turret milling machine factory more troublesome, to adjust the pulse, pulse width, pulse. The trouble... The change in value is too large. Hard to say.
The same type of wire cutting, the practice between manufacturers is different, the performance is not the same. The cutting efficiency is also different.
No-load voltage is the voltage that turns on the high frequency, but does not process the workpiece. When processing, with the thin thickness of the workpiece changes, the no-load voltage will also change, and the voltage will be lower than the no-load voltage during processing, which is the so-called load. The thickness is different, the load is different.
high accuracy mini universal turret milling machine factory There is a regulator inside the control box, and a rotary switch is connected to the outside. The switch can be rotated back and forth to adjust the voltage. (When cutting, it is strictly prohibited to adjust the pressure, change the pulse width, pulse between the parameters. There is a risk of breaking wires and destroying circuit components).
high accuracy mini universal turret milling machine factory https://www.talentcnc.com/Turret-milling-machine
Comments (0)